証券コード M09
Ice Toolz 12 Tooth External Bottom Bracket Tool
- For FSA BB386Evo, Hawk Racing BB3086, RaceFace Cinch, Rotor BSA30, Zipp Vuma and other external bottom bracket systems.
- Hardened CrMo steel.
- Use with 1/2" driver.
Mr WestonWell made tool that does the job.
Mr LabanDoes the job it's intended for with no fuss, nothing to fault.
Mr McMillanA really nicely made tool - fits a SRAM DUB BSA BB perfectly. Made servicing a breeze.
Mr LunanGood tool, does the job for sram dub.
Mr HutchinsonDoes exactly what it says, high quality and perfect for sram dub threaded bb
JoshPerfect fit for a SRAM DUB BB and much stronger and a more snug fit than the Park Tool one. Merlin spot on with delivery as usual.
C TNot actually used it yet but it appears to be of a high quality and leaves me feeling confident it will do its job without problems.
JamesyGreat tool, I was desperate for it and it came in good time.
Mike ChinaSeems robust enough, does what is supposed to do.
DavidQuality bit of kit, I purchased it to fit a SRAM DUB ITA Bottom bracket. No issues whatsoever.
Mr SmithThe tool is just about okay. It can slip fairly easily, but with perseverance it works. Not as good as shimano hubs for fitting
Mr ChapmanWorks well to remove and install 24 or 12 tooth bottom brackets, would recommend. Shame it doesn't come with a case.
Liam BucklerI actually bought this to fit an SRAM DUB BSA bottom bracket, This BB isn't listed in the compatibility (either with Icetoolz or Merlin) but i was advised independent that DUB uses the same tools as RaceFace Cinch so this should fit, and it worked perfectly - a nice tight fit with no flex or wiggle, no issues tightening to the required 54nm torque and there are no signs of scratches or paint chips on the BB after using - recommended!
StuCheaper then the park tool variant and does exactly the same. Purchased this to install a sram dub bsa 30 B/B and it did the job no problem.
Steve ThomsonNice solid product, far better than other flimsy alternatives
Peter ChownI bought this to fit a Sram Dub bottom bracket. Solid bit of kit and worked perfectly, highly recommend!
WillNice quality. Does the job 10x better than the crappy nylon one that came with my bb
GARYpurchased to remove DUB bb. Fits onto a 1/2 inch drive ratchet/t-bar/breaker bar. Fits the bb shell snuggly. This is made from hard material and is built to last. Unlike the park tool bb removal tool that it had replaced, which was more expensive, super soft and was rendered useless after removing one tight bb shell.
Mr LorrimanPerfect tool for the job on my Sram threaded DUB BB
Mr LeeWorked well on Rotor bottom bracket
chrisI brought this for use on a sram dub bsa bottom bracket. Fits securely on the notches. Seems strong enough for the intended usage.
