Shimano Ersatzschlauch-Sets für Scheibenbremsen

Dieses Produkt ist leider nicht mehr verfügbar!
Replacement Shimano Disc Hose Kits ist bei Merlin Cycles nicht mehr erhältlich. Vielleicht findest du aber unten ein alternatives oder aktualisiertes Produkt.

5 / 5

- Lies 10 Bewertungen

View all MTB Brake Cables & Hoses

Dieser Artikel wurde eingestellt 29th October 2024.

Wenn du Hilfe bei der Suche nach einer Alternative zu diesem Produkt benötigst, wende dich bitte an den Kundendienst.

Code:: 765

Shimano Ersatzschlauch-Sets für Scheibenbremsen

Original Shimano schneidbare Schlauchkits.
Vorne sind 900mm oder 1000mm lang.
Die Hinterräder sind 1700mm lang.
Inklusive aller notwendigen Beschläge.

Wähle dein Lieferland<

Barrie Just what i needed when changing the hose on my brakes, came with all the bits required, at the usual fantastic Merlin prices, and quick delivery

Dimitrios Replaced my Shimano 785 XT brake line. Comes with everything necessary, minus the fluid, for a hose change.

Baines Bought to replace an original XTR hose which was too short. The hose has the same right angle eyelet and looks/fits in an identical fashion to the XTR version it replaces on an 2011 XTR race brake setup

Aussie Scott Has all the parts required to replace old hose. Yellow cable holder works well when trying to put insert into hose. I used some vice grips to hold hose in place with yellow holders, then tapped insert in with a soft rubber mallet. Easy as.

Mr Fletcher Great for the job intended. I replaced SLX Calipers with 2013 model which require these hoses with the banjo fitting.

Mr Jackson Great replacement, easy to install. Cheaper and better than aftermarket alternatives, like Jagwire.

Mr Pikesley Great product, and a superb service as always. Thanks keep up the good work.

Mr Sampson Does what it is ment to do and not that expensive.

Mr SHERIDAN Bought the front kit to replace my Shimano SLX front brake hose. It was different to what was on the picture. Only one oilve and a different connection at the other end. I found out it was for an XTR brake. This wasn't clear on Merlin's website. I had to order another olive seperate.

Mr Gould If you run dual crown forks youre going to need a rear hose up front. Other than that they're perfect!! Get one of these to bleed em though: http://bit.ly/NLGDGM